Enrange WIC-2402™ Wireless CAN Module

Magnetek’s WIC-2402 transceiver is a 2.4GHz wireless data system for connecting CAN-based devices without the need for interconnecting wires. The WIC-2402 system transmits and receives (transceives) all CAN messages present on the CAN-bus just as if they were connected with wires, providing dependable control and fast performance. The modules can be used with most existing systems without the need for programming changes. A basic system includes one server module, a client module, and all necessary hardware. Custom configurations are available to meet your specific requirements.

Simple in Challenging Places

• Supports any type of Bosch 2.0b CAN network, including J1939, CAN Open, Device Net, Parker ICP, and more, with little or no programming
• More efficient and dependable than cables over long runs and moving joints
• Ideal for mobile applications that require access to stationary based CAN-bus networks
• Increases reliability by removing the cable, a failure point within many systems
• Sends data across areas where cables can be damaged or where running cable is not practical
• Eliminates the need to use slip rings for communication

Flexible and Fast Performance

• Configure which CAN message get transmitted wirelessly by setting message filters with RCP
• Fast response time— messages are transmitted and received with less than 30 milliseconds latency
• Wide operating voltage range of 9-36VDC
• Communicates over long ranges, up to 1,500 feet
• Reduces field service and maintenance costs
• Features bright LED lights for diagnostics and system status
• Rated NEMA 4 (IP66), sealed to withstand harsh mobile and industrial environments
• Quick plug Deutsch connector makes integrating into the machine easy
• Reliable in crowded RF bands with Frequency Hopping Spread Spectrum (FHSS) technology
• Custom configurations available

Typical Applications

• Make CAN-bus control modules mobile
• Communicate to mobile machinery
• Isolate controls for utility truck safety
• Provide data feedback from excavator self-powered attachments
• Transmit data feedback from sensors to CAN gauges

3 Easy Installation Steps for the Standard WIC-2402

1. Cut CAN cable
2. Connect CAN cable ends to the WIC-2402
3. Power the WIC-2402 with 9-36VDC

No program setup required. It’s that easy!