SSP Stainless Screw Jack, with swivel brackets

The entirely newly developed series of stainless worm gear screw jacks SSP has been designed specifically for the tough requirements of e.g. modern paper machines.

This new series is based on a standardized construction kit, which may be combined individually.  

Due to high-grade stainless steel and innovative technology there should not be any obstacle anymore to a mechanical lifting solution in the field of steel hydraulics construction, food industry as well the explosion-proof area.

Equipment and processing

• 4 different sizes
• Lifting capacities from 50 to 250 kN 
• Input speeds up to 1500 min-1
• Complete stainless design
• Self-locking trapezoidal screw
• Grease-lubricated configuration
• Worm gear pairs in two ratio steps (normal „N“ and slow „L“)
• Worm-drive shaft quenched and ground
• Motor flange screwable from the outside
• Housing with swivel brackets
• Standard fastening for motors
• Chamfer at the header to fasten the protection boot
• FEM optimized housing
• Identically constructed to European manufacturers
• Possible usage according to directive 2014/34/EU (ATEX)

A wide range of applications such as: paper industry, hydraulic steel construction, food and beverage production, chemical industry, offshore, weatherproof outdoor use, explosion-proof areas