Budgit formed-channel end trucks are designed with safety, reliability, and performance in mind. Built for single-girder applications, Budgit end trucks are available in both under-hung and top-running styles. Whether you need push-type, hand-geared, or motorized configurations, Budgit end trucks are an economical and easy-to-install option for any crane system or application.
CAPACITY: Up to 5 tons
SPAN: Up to 48 ft.
A right-angle, shaft-mounted worm drive gear reducer can be mounted at either end of the bridge. The gear reducers can be mounted on either top-running or under-hung end trucks. Traverse reducer provides stopping motion of the bridge within a distance in feet equal to 10 percent of full load speed in feet per minute (traveling at maximum speed with maximum rated load).
Drive motor is a 1/2 or a 3/4 horsepower squirrel cage motor that is NEMA design 30-minute rated TENV with Class âFâ insulation. The motor is provided with thermal overload protection as standard, with C-face mounted to the gear reducer. Single-phase and three-phase motors (½ hp only) are available. Voltages available in single and two speed are 208-230-460-575 volt-3ph-60Hz. Voltages available in single speed only are 115-230 volt-1ph-60Hz. Contact us for any other special speeds or voltages.
The cross shaft couplings connect the cross shaft to the pinion shaft at each end truck, as well as couple sections of cross shaft.
Features lifetime-lubricated bearings. For hand-geared and single-drive, motor-driven cranes, cross shafts are required. The cross shafts are to be 1â diameter AISI 1018 cold drawn steel.
The control panels include mainline contactor, 115-volt control circuit transformer with fused secondary terminal strip, bridge fusing, and reversing contactor in a NEMA 1 enclosure. NEMA 4/12 panels are available as an option.
Fused disconnect switch box has positive power disconnect and crane fusing. NEMA 1 enclosure is standard with NEMA 4/12 available as an option.
North America - EN
